|
Post by ploddit on Sept 29, 2015 5:19:42 GMT 1
I'm just installing the original balance weights as I get a tingly hand after long trips and the bike didn't have any. I was wondering the pupose of all the fixings and found this at the Hawk US site. Didn't think of that I must say. Although with hindsight I don't think the revere system is exactly the same. Ours are the same as a Goldwing 1800! Much like this CBR1000, I must check if we have locating holes for the clips in the bars because I don't think so. With this thread I think that's it covered quite well. NC700 forum
|
|
|
Post by ploddit on Oct 24, 2015 5:10:06 GMT 1
Done!
I can confirm we have the same system with two holes at 180° and a small triangular protusion exactly like the CBR film which clicks into the holes. On my metal parts both of the little tabs were broken, but luckily had ordered two new ones. I will update if the addition of heavy end weights changes my pins and needles feeling after a long drive - 1000km next week.
|
|