Interesting top yoke conversion...

[thatsawkward]

Saw this on ebay.de - interesting concept but silly price (roughly £200!).

If it was possible to make it cost effective would make a simple Revere to NTV conversion without the faff of moving the fuse box....



www.ebay.de/itm/LSL-Superbike-Kit-Lenkeradapter-Honda-NTV-650-Hawk-RC-31-alle-Umbau-Klemmbocke-/350558280744?pt=Motorrad_Kraftradteile&hash=item519ee6dc28#ht_2371wt_989

[noakira]

Q: You would have to raise the forks by 10mm for these clip onto for the Revere?

When you unbolt the Revere handles the top screw caps of the forks are flushed with the level of the yoke beneath, nothing to clip onto ?

Still you would have thought there would be an easy conversion kit available for such an obvious modification....

[rj2para (Bisto)]

If you could buy the bar holding section you could drill and bolt this to some flat alli sheet and bolt that down as we do with our existing bars.

[thatsawkward]

May 3, 2012 10:05:15 GMT 1 noakira said:

Q: You would have to raise the forks by 10mm for these clip onto for the Revere?

That's a good point, though I'm not convinced that simply dropping the top yoke by 10mm will make much difference would it? I'm sure Honda would say it would destroy the perfect balance and geometry, but I'd be willing to give it a go

[yellowmelos]

Normally dropping the forks down would increase the ability to turn but would make high speeds less stable, raising them up would have the opposite affect.