notlob
Hits the TON !
Posts: 112
|
Post by notlob on May 4, 2014 21:55:51 GMT 1
Pulled my Revere out to start it up after the winter. Starts fine and runs well. Temp get up and the fan doesn't run. Water gets hot and vents. To sort this out I run a wire from the temp sensor to earth, with the ignition on I earth the wire and the fan won't run. I know exactly what's wrong and order a new temp sensor for around £50. Strip rad off, wire directly to the battery and earth the other leads. Fan runs fine. Check the bloody fuse you tosser There was even a spare fuse in the box ATB Ray.
|
|
seastate
A-Road rider Limited to 70
Posts: 74
|
Post by seastate on May 5, 2014 9:18:46 GMT 1
that sounds so familiar
|
|
undercover
All Weather Rider, well hard
Posts: 186
|
Post by undercover on Jun 18, 2014 1:17:25 GMT 1
i have the exact opposite problem bought a ntv fan on ebay and the haynes manual is telling me to fit the bloody thing i really want to test it first is there any easy way there looks like a wire missing from the white plug there is only 2 wires connected but 3 spaces for wires in the white connector youtu.be/M-AnBhJvLs4
|
|
|
Post by ploddit on Jun 18, 2014 11:43:40 GMT 1
Only needs two + and - but your wire looks botched, put plus to the red one and earth the round one to check.
|
|
undercover
All Weather Rider, well hard
Posts: 186
|
Post by undercover on Jun 18, 2014 17:42:32 GMT 1
Yeah looked at the Haynes and it says blue/black and black/blue the red fitting is not standard But it doesn't work that's evil bay as usual
Even though £24 my fan holder is rotten so it's a lot cheaper than buying A new one But my temp gauge went up to the red yesterday in heavy traffic not too much of a worry. In the UK lol
|
|