|
Post by De Graaf van Salland on May 2, 2009 20:01:24 GMT 1
I've made a support to go under my side stand. So I can park my bike on soft ground. Or in positions where the ground isn't level. Also, if the bike is loaded; it will keep it a bit more upright. It's made out of two short pieces of square aluminium tube 30x30 mm / Length = 120 mm. The 2 pieces are glued together using a 2-component epoxy glue. I've put a bit of string through it, that you can put over the gear lever. This way you wont forget the support when you drive off. Also it's small enough to fit in the compartment in front of the rear light. See photo's: I've made 3 of these, but I only need one. So if anybody wants to have one. I'll sell them for € 5,= each, excluding postage & packaging. Send me a "pm" if you want to buy one. Franklin
|
|
|
Post by McF on May 3, 2009 8:13:35 GMT 1
Franklin you de man!
Great job, well done. The whole thing is a great idea, but I like the string!
Good idea with the production line. I'd be placing an order, but as I'm already paranoid about bikes falling over (it's happened to me a few times), I have already bought something to do the trick.
|
|