|
Post by yellowmelos on Feb 7, 2010 10:53:56 GMT 1
Does anyone here have a picture of.. or a schematic of the swing arm setup and and bushes as you know i have a NTV trike and the bushes actually fix from the inside out ( not the outside in ) but there is some movement which failed the MOT so before i start pulling this apart... would like some picture. Cheers People
|
|
|
Post by McF on Feb 7, 2010 22:39:47 GMT 1
Does anyone here have a picture of.. or a schematic of the swing arm setup and and bushes as you know i have a NTV trike and the bushes actually fix from the inside out ( not the outside in ) but there is some movement which failed the MOT so before i start pulling this apart... would like some picture. Cheers People It's a bearing not bushes - Ball Bearing I think, but I may have that confused with my boxers They are adjustable, using the pivot bolt on the starboard right side. If you're still using the standard pivot bolts (from an NTV600 or NTV 650) etc follow this process: Loosely assemble both pivot bolts etc Tighten the Port Left side pivot bolt to 100Nm Tighten the Starboard Right side pivot bolt to 12Nm, then back it off and retighten to Nm Tighten the Starboard Right side pivot bolt lock nut to 90Nm (you will need a special tool to enable you to hold the pivot bolt still while you do this You use a large allen key through the special tool and tighten the special tool Good luck and do let us all know how you get on
|
|
|
Post by yellowmelos on Feb 8, 2010 18:22:19 GMT 1
Cheers !!!
|
|